Removing The Display Assembly; Replacing The Display Assembly - Dell Latitude D530 Service Manual

Back to Contents Page
Display Assembly
Dell™ Latitude™ D530 Service Manual
Removing the Display Assembly
Removing the Display Bezel
Replacing the Display Bezel
Display Panel
Display Latch
Removing the Display Assembly
CAUTION: Before you begin the following procedure, follow the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see
computer.
1. Follow the instructions in Before Working Inside Your
2. Remove the hinge cover (see
3. Remove the keyboard (see Keyboard).
4. Remove the captive screw that grounds the display cable.
5. Disconnect the display cable from the display cable connector on the system board.
6. Disconnect the three Mini-Card antenna cables (see Mini-Card).
7. Disconnect the antenna cables from the display by holding the two gold antenna connectors on each connector and gently pulling them apart.
1 M2.5 x 5-mm screws (4)
4 display connector on system board 5 antenna cable connectors (3)
8. Remove the four M2.5 x 5-mm screws from the display and remove the display from the computer.

Replacing the Display Assembly

Computer.
Hinge Cover).
2 display cable grounding-wire screw 3 display cable pull-tab
Before Working Inside Your Computer) before working inside the