Table A-1. System-Board Jumper Settings
Jumper
Setting
PASSWD
(default) The password feature is enabled.
NVRAM_CLR
(default) The configuration settings are retained at system boot.
ONCE
jumpered
unjumpered
NOTE:
For the full name of an abbreviation or acronym used in this table, see "Abbreviations and Acronyms."
System Board Connectors
See
Figure 6-1
and Table 6-1for the location and description of system board connectors.
SCSI Backplane Board Connectors
Figure A-3
shows the location of the connectors on the back of the SCSI backplane board.
Figure A-3. Connectors on the SCSI Backplane Board
Description
The password feature is disabled.
The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point where
the system will not boot, install the jumper plug and boot the system. Remove the jumper before restoring the configuration
information.)
Reserved (do not change).