Replacing The Front I/O Panel; Front I/O-Panel Components - Dell XPS 430 Service Manual

Back to Contents Page
Replacing the Front I/O Panel
Dell™ XPS™ 430 Service Manual
Front I/O-Panel Components
CAUTION: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
Front I/O-Panel Components
1 add-in audio internal
connector
4 front I/O connector
7 USB 2.0 connectors (2)
To replace the front I/O panel:
1. Follow the procedures in Before You
2. Remove the computer cover (see
NOTICE: Carefully note the routing of each cable before you disconnect it, so that you are sure to re-route cables correctly. An incorrectly routed or a
disconnected cable could lead to computer problems.
3. Remove the front plastic bezel:
a. Remove the drive panel (see
b. Remove the two screws from the bottom of the chassis.
c. Press out to release the six tabs that secure the bezel to the front panel.
d. Pull the bezel away from the front of the computer.
1 Bezel tabs (6)
2 1394a internal connector 3 power button connector
5 microphone-in connector 6 headphone-out
connector
8 1394a external
connector
Begin.
Removing the Computer Cover).
Replacing the Drive Panel).
2 Bezel screws (2)