6. Remove the memory module from the memory-module connector.
Replacing the Memory Module(s)
CAUTION:
If you need to install memory modules in two connectors, install a memory module in the connector labeled "DIMM A" before you
install a memory module in the connector labeled "DIMM B".
1. Follow the instructions in
Before You
2. Align the notch in the memory module with the tab in the memory- module connector.
3. Slide the memory module firmly into the memory-module connector at a 45-degree angle, and press the memory module down until it clicks into place. If
you do not hear the click, remove the memory module and reinstall it.
NOTE:
If the memory module is not installed properly, the computer may not boot.
1
tab
2
3
memory-module connector
4. Align the tabs on the memory-module cover with the slots on the base cover and snap the memory-module cover into place.
5. Tighten the two captive screws that secure the memory-module cover to the base cover.
6. Replace the battery (see
Replacing the
7. Connect the AC adapter to your computer and an electrical outlet.