1
tab
2
palm-rest assembly
9. Using your fingertips, gently ease the palm-rest assembly from the computer base.
10. Without pulling hard on the palm-rest assembly, place it away from the display as shown in the illustration below.
11. Lift the connector latch and pull the pull-tab to disconnect the touch-pad cable from the system-board connector.
12. Disconnect the control-strip cable from the system-board connector.
CAUTION:
Carefully separate the palm-rest assembly from the computer base to avoid damage to the palm-rest assembly.
13. Lift the palm-rest assembly off the computer base.
1
control-strip cable
3
tabs (3)
5
pull tab
2
top cover
4
palm-rest assembly
6
touch-pad cable connector