Removing The Display Bezel - Dell Inspiron 9400 Service Manual

1 shoulder screws (4, two at the top and two at
the bottom)
4 rubber screw-covers/display bumpers (6)

Removing the Display Bezel

CAUTION: Before you begin the following procedure, see the safety instructions in the Product Information Guide.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such
as the back panel) on the computer.
NOTICE: To help prevent damage to the system board, remove the main battery (see
computer.
1. Follow the instructions in Before Working Inside Your
2. Remove the display assembly (see
3. Remove the six rubber screw-covers/display bumpers.
4. Remove the two screw covers and the four shoulder screws.
5. Remove the four M2.5 x 5-mm screws at the corners of the bezel.
NOTICE: Removal of the bezel from the display back cover requires extreme care to avoid damage to the bezel.
6. Use your fingers to separate the bezel from the display back cover by pulling the lower-right corner of the bezel down toward the bottom edge (A) of
the display assembly to clear the tab on the bottom of the lower-right corner. Then pull the bezel toward the right side of the display assembly to clear
the tab on the side (B) of the lower-right corner.
2 screw covers 3 M2.5 x 5-mm
(2) screws
(4, one on each
corner)
5 display bezel
Computer.
Removing the Display Assembly).
Before Working Inside Your Computer) before working inside the