Replacing The Display Assembly - Dell Inspiron 9400 Service Manual

5. Remove the hinge cover (see
6. Use the pull-tab to disconnect the display cable from the system board, and then disengage the display cable from the cable channel.
7. Remove the four M2.5 x 5-mm screws (two on each side) that connect the display to the computer base.
1 display cable in cable channel
1 Mini-Card antenna cables
NOTICE: When removing the display assembly, carefully unthread the Mini-Card antenna cables through the computer base.
8. Lift the display assembly away from the computer.

Replacing the Display Assembly

1. Thread the Mini-Card antenna cables back through the hole in the base of the computer so that they are accessible from the bottom of the computer.
Removing the Hinge Cover).
2 display cable pull-tab 3 M2.5 x 5-mm screws (4)