Removing The Palm Rest - Dell Studio 1555 Service Manual

Back to Contents Page
Palm Rest
Dell Studio™ 1555 Service Manual
Removing the Palm Rest
Replacing the Palm Rest
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as the back panel) on the computer.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION: To help prevent damage to the system board, remove the main battery (see
inside the computer.
Removing the Palm Rest
1. Follow the instructions in Before You
2. Remove the base cover (see
3. Remove the eight screws from the bottom of the computer.
4. Remove all the Mini-Cards (see
5. Remove the antenna cables from their cable routing.
6. Disconnect the display cable, camera cable, and the power button cable from the respective system board connectors (see
Assembly).
7. Disconnect the touch pad cable and speaker cable from the respective system board connectors.
8. Remove the ten screws on the palm rest.
CAUTION: Do not use force to separate the palm rest from the computer. If you encounter resistance, gently flex or apply pressure to the palm
rest, or move along the edge, working away from the area of resistance, until the palm rest is free.
Begin.
Removing the Base Cover).
Removing the Mini-Card).
Before Working Inside Your Computer) before working
Removing the Display