Installing The System Board; Replacing The Computer Cover - Dell XPS 410 Service Manual

Hide thumbs Also See for XPS 410:
Table of Contents

Advertisement

3. Disconnect any telephone or telecommunication lines from the computer.
 
4. Disconnect your computer and all attached devices from their electrical outlets, and then press the power button to ground the system board.
 
5. Open the computer cover (see
 
6. Remove any components that restrict access to the system board (CD/DVD drive(s), floppy drive, hard drive, I/O panel).
 
7. Remove the heat-sink assembly and processor.
 
8. Disconnect all cables from the system board.
 
9. Remove any memory modules that you are transferring to the new system board (see
1
system board
 
10. Remove the 10 screws from the system board.
 
11. Slide the system board assembly toward the front of the computer, and then lift the board away.
 
12. Place the system board assembly that you just removed next to the replacement system board to ensure that it is identical.
 

Installing the System Board

 
1. Gently align the board into the chassis and slide it toward the back of the computer.
 
2. Replace the screws on the system board.
 
3. Replace any components and cables that you removed from the system board.
 
4. Install the memory modules that were removed from the old system board (see
 
5. Reconnect all cables to their connectors at the back of the computer.
 
6. Replace the computer cover (see
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug the cable into the computer. Connect your
computer and devices to electrical outlets, and turn them on.
If the new system board requires flashing the BIOS refer to
 Replacing the Computer Cover
 
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
 
1. Ensure that all cables are connected, and fold cables out of the way.
Gently pull the power cables toward you so that they do not get caught underneath the drives.
 
Removing the Computer
Cover).
2
screws (10)
Replacing the Computer
Cover).
Flashing the
Removing
Memory).
Installing
Memory).
BIOS.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents