9. Route the USB cable through the cable routing clip.
10. Replace the computer cover (see
CD/DVD Drive
CAUTION:
Before you perform any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before opening the cover.
NOTE:
If removing or installing the drive changes the drive configuration, you must reflect the changes in the BIOS. Go to the "Drives" section of the
BIOS and under SATA 0 through 5, set the SATA ports to the correct configuration.
Removing a CD/DVD Drive
1. Follow the procedures in
Before You
2. Remove the computer cover (see
3. Disconnect the power cable from the back of the drive and the CD/DVD drive cable from the back of the drive and the system board.
1
CD/DVD drive cable
4. Slide the drive release mechanism to the right to release the shoulder screw and slide the drive out to remove it from the drive bay.
1
sliding plate
Installing a CD/DVD Drive
Replacing the Computer
Cover).
Begin.
Removing the Computer
Cover).
2
power cable
3
system board
2
CD drive