Advertisement
Quick Links
TN-4005 / TN-4008 Install Guide
3 Wire minimum connections
Black Wire – Chassis Ground
Red Wire - +12v Constant Input. Connect to constant +12v power source
White Wire - + Ignition source.
Optional Connections
Green Wire – 1 amp negative output for starter disable
Yellow Wire – Test wire for starter disable (optional) Ground this wire momentarily
(one second) after installation. This will test Starter Disable output. The relay will
close and open the starter circuit for 30 seconds. If properly installed, the vehicle
should not turn over / start during this time. The test will send a message to the
device "History" that reads "Installation Test Sequence" on the website.
Blue Wire – (-) Alarm Input Trigger. After 27 seconds of a constant negative input
from your vehicle alarm, this will send a message to the device.
Violet Wire – (-) Door Unlock Wire
Label side of module must be facing up.
Make sure vehicle is parked outside, in clear view of the horizon for GPS to "lock
in".
Orange and Yellow L.E.D.'s will stay on solid once unit has GPS lock and Cell lock.
Fax EQUIPMENT & SERVICE AGREEMENT to 805.581.9500
Crimestopper Security Products, Inc.
1770 S. Tapo Street
Simi Valley, CA 93063
Tel: 805.526.9400 Fax: 805.581.9500 Toll Free: 800.998.6880
Email: support@crimestoppertraknet.com
Advertisement
