Simulator And Feature Memory - Teleflex TFX320 Operation Manual

POWERING UP THE 320
After installation, turn the 320 on by momentarily pressing the G
audible chirp sounds as the unit turns on. If the unit detects that the transducer
is connected and is in water, the 320 begins to show sonar information on the
display. If the transducer is not detected, the unit starts up in simulator mode.
To power the unit off at any time, press and hold the G
seconds until the 320 turns off.

SIMULATOR AND FEATURE MEMORY

The 320 contains a simulator that allows you to use the unit as though you are
on the water. The Simulator is an invaluable aid to learning the features and
functions of the 320. All controls are operational and settings can be changed
to experiment with various features. When operating in Simulator an indicator
appears at the bottom left of the display.
There are two ways to start the simulator. The method to use depends on whether a
transducer is connected:
If the 320 is powered on with no transducer connected, it starts up in simulator
mode. No other steps are needed. In this mode the 320 does not remember
any setting changes that are made.
If the 320 is powered on with the transducer connected, the Simulator must
be manually turned on.
To manually turn the simulator on:
1. Press the Control Panel knob to display the list
of options.
2. Rotate the Control Panel knob to scroll through
the list until Simulator is visible and is highlighted on the display.
3. Turn the Range knob to turn Simulator from
OFF to ON.
4. Press the Control Panel knob to clear the screen.
USING THE 320 SERIES
POWERING UP THE 320/SIMULATOR
knob. An
AIN
knob for several
AIN
3