USING THE 100ID SERIES
INTRODUCTION
INTRODUCTION
The 100ID series is easy to use. Simply press the POWER button, and the
unit will automatically locate the bottom, adjust the depth range and
sensitivity to an appropriate level, and draw a picture of the terrain
beneath your boat. If POWER is the only button you press, you will bene-
fit from the advanced automatic bottom tracking capability of the unit.
However, if you choose to experiment with the many features and
controls the 100ID offers, you can customize the presentation of informa-
tion to suit your particular needs. The 100ID offers a wide variety of
settings and types of display, to satisfy any sonar need.
SIMULATOR OPERATION
The 100ID contains a simulator which allows you to use the unit as if you
were on the water. This simulator is invaluable for learning how to oper-
ate the many features of the 100ID unit.
With the unit turned off, press and hold POWER until you hear a continu-
ous chirp. This initiates the simulator operation. Your 100ID will simulate
all functions as if it were actually on the water.
To exit the simulator, press POWER to turn the unit off. Pressing POWER
again will power-up the unit for normal operation.
When in simulator operation, the
100ID unit will respond to control
inputs as if it were in actual opera-
tion, so feel free to experiment with
the many features and functions to
customize the 100ID unit for your
particular application.
USING DEPTH OFFSET
Depth Offset adjusts the digital
depth readout to show distances
approximated from either the water-
line, or the lowest point of the hull.
This is accomplished by selecting an
3
Depth Offset at Zero