Entering Titles - Clarion VXZ766 Owner's Manual

OPERATIONS
Adjusting the auxiliary input
sensitivity
Adjust the auxiliary sensitivity when the audio
from an external device is difficult to hear even
after adjusting the volume.
• The factory default setting is "MID".
1. Press the [ADJ] button to switch to the adjust
mode.
2. Move the [ ] / [
SENS".
3. Turn the [ROTARY] knob to select from
"LOW", "MID" or "HIGH".
4. Press the [ADJ] button to return to the
previous mode.
Performing a system check
This function verifies the devices hooked up
through CeNET.
1. Press the [ADJ] button to switch to the adjust
mode.
2. Move the [ ] / [
"SYSTEM".
3. Press and hold the [
or longer to start the system check.
The digital connection configuration is
automatically checked.
4. When the system check is complete, perform
the speaker setting.
Turn the [ROTARY] knob to select the
speaker system and press the [
The display returns to the previous mode.
For details on the speaker setting, refer to
the "System check and speaker setting"
(P. 16).
Note:
• When the speaker setting has been changed by a
system check, the previously set "AUDIO SETUP"
returns to its default setting.
42
VXZ766
] lever to select "AUX
] lever to select
] button for 1 second
] button.
Other operations

Entering titles

Titles up to 8 characters long can be stored in
memory and displayed for CD, CD changer and
Radio/TV stations. The number of titles that can
be entered for each mode are as follows.
Mode
CD mode
TV mode
Radio mode
CD changer mode
DCZ625 connected
CDC655Tz connected
1. Press the [SRC] button to select the mode
you want to enter a title (Radio, CD, CD
changer or TV).
2. Play a track or tune in to a radio/TV station for
which you want to enter the title.
3. Do one of the following:
In the CD or CD changer mode:
Press the [TITLE] button to select "USER TITL".
In the radio or TV mode:
Skip this step.
4. Press and hold the [TITLE] button for 1
second or longer to switch to the title input
display.
5. Move the [ ] / [
cursor.
6. Press the [BND] button to select a character.
Each time you press the [BND] button, the
character changes in the following order:
Capital letters ➜ Numbers ➜ Symbols ➜
Umlaut ➜ Capital letters...
7. Turn the [ROTARY] knob to select the desired
character.
8. Repeat steps 5 to 7 to enter up to 8
characters for the title.
9. Press and hold the [
seconds or longer to store the title into
memory and return to the previous mode.
Number of titles
50 titles
20 titles
30 titles
Number of titles
100 titles
100 titles
] lever to move the
] button for 2