28
Dell Inspiron 7500 — Removing and Replacing Parts
This procedure assumes that you have removed the heat exchanger/fan. To remove
the processor board (see Figure 20), perform the following steps:
1.
Remove the three 5-mm screws securing the processor board to the system
board.
2.
Gently pull the processor board off of connector JP15 on the system board. Do
not rock the board to remove it, because this may damage the connectors.
When reinstalling the processor board, align the board with the notch on the system
board connector. Press down on the left side of the board over the system board con-
nector. This is the best spot to apply pressure to seat the processor correctly on
connector JP15.
LCD Removal
Figure 22. LCD Components
1
LCD wire harness
2
Connector JP3