Display Assembly - Dell Inspiron 510M Service Manual

Display Assembly and Display Latch: Dell Inspiron 510m Service Manual
Back to Contents Page
Display Assembly and Display Latch
Dell™ Inspiron™ 510m Service Manual

Display Assembly

Display Bezel
Display Panel
Display Latch
Display Assembly
CAUTION: Before performing the following procedures, read the safety instructions
in your Owner's Manual.
NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or
by periodically touching an unpainted metal surface (such as the back panel) on the computer.
NOTICE: You must remove the display assembly before you remove the palm
rest.
1. Follow the instructions in
2. Remove the keyboard.
3. Open the display assembly approximately 180 degrees, and support the display assembly so
that it does not open past this position.
4. Pull up on the pull-tab that is attached to the display cable connector to remove the connector
from the system board.
5. Release the display cable from the three display-cable routing clips.
file:///I|/SERVICE%20MANUALS/DELL%20MANUALS/LA...ecked%20ok/Inspiron/510M/510M%20SM/display.htm (1 of 12)6/21/2004 12:34:56 AM
"Preparing to Work Inside the Computer."