Table of Contents
Advertisement
L i f e B o o k P 7 0 0 0 N o t e b o o k B I O S
SECURITY MENU - SETTING THE SECURITY FEATURES
The Security menu allows you to set up the data security
features of your notebook to fit your operating needs
and to view the current data security configuration.
Follow the instructions for Navigating Through the
Setup Utility to make any changes.
The following tables show the names of the menu fields
for the Security menu and its submenus, all the options
for each field, the default settings and a description of
the field's function and any special information needed
to help understand the field's use. The default condition
is no passwords required and no write protection.
Remember your passwords! If you set and
forget your User and Master hard disk
passwords, Fujitsu Computer Systems
service representatives (1-800-8FUJITSU)
may not be able to reset it. You may lose
data and have to replace your system
board or hard disk drive.
Main
Supervisor Password Is:
User Password Is:
Set Supervisor Password
Set User Password
Minimum User Password Length
Password on Boot:
On Automatic Wake up:
KB Lock on Resume:
Boot from Removable Media:
Flash Write:
Hard Disk Security
Owner Information
Security Chip Setting
F1
Help
ESC
Exit
20
PhoenixBIOS Setup Utility
Advanced
Security
Boot
Clear
Clear
[Enter]
[Enter]
[0]
[Disabled]
[Disabled]
[Disabled]
[All]
[Enabled]
Select Item
-/Space
Select Menu
Enter
Figure 12. Security Menu
Entering a password incorrectly 3 times
■
in a row causes the keyboard and mouse
to be locked out and the warning
[System Disabled] to be displayed.
If this happens, restart the computer by
turning off and on the power with the
power switch and use the correct pass-
word on reboot.
If you make an error when re-entering
■
the password a Warning will display
on the screen. To try again press [Enter],
then retype the password. Press [Esc] to
abort the password setting process.
■
If the Power Management Security is
Enabled and the Password on Boot is
Disabled you will not have to type your
password upon resuming the system
from the Standby or Hibernate modes.
Power Management Security will work
only if Password boot is enabled.
Boot sector protection must be set to
■
[Normal] to install or upgrade an
operating system.
Info
Exit
Item Specific Help
Press <Enter> key to
set Supervisor Password
to enable any password
features.
Then password entry is
required to enter BIOS
Setup.
Change Values
F9
Setup Defaults
Select Sub-Menu
F10
Save and Exit
Advertisement
Table of Contents
