About The Ice And Water Dispenser - Hotpoint 20 Owner's Manual And Installation Instructions

About the automaticicemaker.
It is normal fi_r several cubes to be joined together.
If ice is not used frequentl}; oM ice cubes will become
doud;4 taste st_de, and shrink.
Icemaker Accessory Kit
If your refrigerator did not come zdready equipped
widl an automatic icemaker, an icemakcr accesso W ldt
is availal01e at extra cost. Check die back of die
refrigerator tbr die specific icemakcr ldt needed fi0r
your model.
About the ice and water dispenser, some mo el.)
{,,) _ o,]
Spill S helf
To Use the Dispenser
® • •
Pressthe glass gen@ against the top of the
dispenser cradle.
The spill shelf is not self<kaining: To reduce
water spotting, the shelf and its gTilleshould be
cleaned reglflarl?:
Locking the Dispenser (onsomemodels)
O -_ Press die Lockpad
_ t}0r3 seconds to lock the
LockJ
dispenser and control pmlel. To
lmlock, press and hold
Hold 3
seconds tile pad again tbr 3 seconds.
finD water is dispensed when the refrigerator is
first installed, there may be air in the water line
system, Press the dispenser arm for at least two
minutes to remove trapped air from the water line
and to fill the water system, Toflush out impurities
in the water line, throw away the first six glassfuls
of wateL
CAUtiON,"IVeverput fingers" or any other
objects into the ice crusher discharge opening,
Dispenser Light
• This pad turns die nightlight in
LL t] the C_sPe'lser OIl alld 01_ The
igh light also comes on when die
dispenser cradle is pressed. If this
light Nlrns out, it sholfld be
replaced with a 6 watt mmximmn,
12 x_oltDC Hill0.
' Ice Storage Drawer on Dispenser Models
[o remove,"
Slide the icemakcr power switch to the 0FFposition. Pldl
die drawer straight out and diet, lift past die stop position.
Toreplace:
When replacing die drawer, make sure to push it firmly
into place. If it does not go all die way back, remove it and
rotate die drive medlanism l/4 turn. Then push die
drawer back again.
important Facts About Your Dispenser
Do not add ice from trays or bags to the storage bin. It may
not crush or dispense well.
Avoid c0verfilling glass with ice and use of narrow glasses.
Backed-up ice can jam the dmtc or cause the door in the
dmte to freeze shut. If ice is blocldng the chute, poke it
through with a wooden spoon.
Beverages and fi0ods shouM not be quick-dlil]ed in die ice
storage bin. Cans, bottles or fi0od pa&ages in die storage bin
may cause die icemakcr or alger to jam.
To keep dispensed ice from missing die glass, put die glass
dose to, Nit not toudling,
die dispenser c0pening:
Some crushed ice may be dispensed even though you selected
Cubed This hal)pens occasionally when a few cubes have been
left in the crusher.
_M'ter crashed ice is dispensed, some water may drip from the
dmte.
Sometimes a small mound of snow will fi0rm on die door in
the ice dmte. This condition is normal and usually occurs
when you have dispensed crushed ice repeatedly: The snow
will eventually evaporate.
The first glass of water dispensed may be warmer than the
fi01k_ving ones. This is normal.
Dispensed water is not ice cold. }:(orcolder ware1; simply add
crashed ice or cubes befi0re dispensing water.