Wiring The Dc-Input Power Source - Cisco 901 Installation Manual

Mounting the Cisco ASR 901 Router

Wiring the DC-Input Power Source

This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that
Warning
the protective device is rated not greater than 10 A minimum, 60 VDC. Statement 1005
Complete the following steps to connect the DC power supply to the Cisco ASR 901 router:
Switch off the DC power source at the circuit breaker, and place the circuit breaker in the Off position.
Step 1
Locate the 6-pin terminal block (part number 27-2030-01)
Step 2
the accessory kit (part number 53-3085-01 for the Cisco ASR 901 router), which is shipped with the
router.
Figure 3-6
Plug the 6-pin terminal block into the power connector located on the front side of the router.
Step 3
Connect one end of the customer-supplied power cord (16-AWG copper wire) to the site DC power
Step 4
source.
Plug the connector on the power supply cord into the 6-pin terminal block that you plugged into the rear
Step 5
of the router in Step 3.
Warning An exposed wire lead from a DC-input power source can conduct harmful levels of electricity. Be sure
that no exposed portion of the DC-input power source wire extends from the terminal block plug.
Statement 122
Warning When installing this unit, secure all power cabling to avoid disturbing field-wiring connections.
Statement 38
DO NOT power on the unit yet.
Caution
Cisco ASR 901 Series Aggregation Services Router Hardware Installation Guide
3-8
6-Pin Terminal Block
Chapter 3 Installing the Cisco ASR 901 Mobile Wireless Router
(Figure 3-6). The terminal block is located in
OL-23778-01