GE ASH08 Owner's Manual & Installation Instructions page 15

Through-the-WallInstallation Instructions--Optional.
The case may be installed throughthe wall in bothexisting and new construction.
Read completely, then follow step-by-step.
IMPORTANT
Through-the-wall installation is not appropriate
if any of the side louvers in the case will be
obstructed by the wall.
All side louvers in the case must project on the
outdoor side of the wall.
The roomside of the case mustproject into the
roomat least 13/4 " fromthe finished wall.
The case mustbe installed level from side-to-side
and with a slight tilt from front to roar. Usea level;
abouta I/2 bubblewill be the correctcaseslant to
the outside.
_] Remo',e the air conditioner frmn the case.
For specific instH/ction, refer to the Window
Installation Instructions.
[_] Make certain a wall receptacle is awfilable
close to the hole location
or make
arrangements to install a receptacle.
E_] Place the case in the wall
o )ening
and
I
secure with 12 1" long #10 wood screws,
NOTE:Drill pilot holes, if neeessary, for proper
installation. If the frame is oversized, use shims
to prevent case distortion.
Finish the Wall Opening
Caulk all fimr sides on the outdoor side of the case to prevent moistm'e from getting through to the
interior wall. Use of flashing (drip rail) will fla'ther prevent water from dripping inside the wall and
down the outside of the building.
, / / /
Lintel angle (if required),_ _ _ _ iiL
Caulking _1 -- Trim molding (if desired)
OUTSIDE
Air louvers
(must project on
the outdoor side
of the wall)
aster line
• Tril _ m_
INSIDE
Bottom rail
Wood Filler and Caulking
(above and below the flashing)
Flashing (Drip rail)
t
4.5 cm (13/4") min.
15