GE ASH08 Owner's Manual & Installation Instructions page 13

Install the Case in the Window
[]Cut the window sash seal to the window width
and stick the adhesixe side to the botton/of
the sash.
_] i,ocate the 3 screw holes along the bottom
front edge of the case. Center the case, side-
to-side, in the window and mtmnt it to the
window sill usim,._ .3 type g screws.
Window sash
seal
_] Thread two b])e C bolts into the support
brackets.
Slide the case into the Mndow and lower the
window behind the top mom_ting rail.
Position the brackets on the case bottom so
they will be near the outermost point on the
window sill. Attnch the suI_po_t brackets to
each side of the case bottom using 4 _])e A
screws on each side. The case should be
slightly tilted to the outside, Use a level;
about a 1/2 1)ubble will be the correct case
slant to the outside.
II
l_ype C bolts
Top mounting rail
Z :re f
'Type B
screws
_] Extend the left and fight accordion panels to
the xertical window sashes and attnch with
4 t},]_e g screws.
Install the Security Bracket and the Foam Top Window Gasket
Cut the foam top window gasket to the
_] Attach the secmi b' bracket with [] window width.
a type g screw.
] Stuff the foam between the glass and the
window to prexent air and insects ti'om
getting into the room.
\
\
/
13