GE AJCM 08,10 Owner's Manual & Installation Instructions page 8

About the controls on the air conditioner
Vent Control
Thevent control islocatedbehindthe front grilleon the
right sideofthe air discharge area.WhenCLOSED, only
the air insidethe roomwill be circulatedand conditioned.
WhenOPEN, the vent allowsoutdoorflesh air exchange.
Toopenor closethe vent:
1. Remove thefront grille.
2. Remove thevent card screw.
S. Remove vent card,turn it overand replaceit by
locatingrear holein cardoverlocatingpin insideair
dischargeand reattachingscrewat front.
Theunit leavesthefactorysetat the CLOSE position.
ocatinghole
OPEN position
(Meshendtowardhack)
hole
Screwhol
CLOSE position
(Meshendtowardfront)
Air Direction
Horizontal l ouvers
on thefront grille
letyou controlthe
air directionup and
down.
front grille
tjustthe vertical
louvers side-to-side
to directthe air left
ht.
Auxiliary Controls - Dip Switches (location varies by model)
The auxiliary dip switch controls are located
behind the room cabinet-as shown in this figure.
The owner is responsible for checking switches
and ensuring they are in the desired position.
FanCycle/Continuous- Cool
\
Fan Cycle/Continuous- Heat (on some models)
\
/ / UP for future use)
IElEa@@loo .
Fan Cycle/Continuous - Cool
When this switch is enabled [UPJ, i t allows the indoor
fan to cycle on/off with the compressor. When this
switch is disabled [DOWNJ,it allows the indoor fan to run
continuously. The default setting is down (continuous).
----[_]Fan Cycle/Continuous- Cool
D :L
Fan Cycle/Continuous - Heat (on some models)
When this switch is enabled [UP),it allows the indoor
fan to cycle on/off with the heater operation. When this
switch is disabled [DOWN),it allows the indoor fan to run
continuously. The default setting is UP(cyclic).
r Fan Cycle/Continuous- Heat (on some models)
Class 2 - Remote Thermostat (on some models)
When this switch is enabled [UP),it allows the unit
to operate with a Class2 Remote Control Wall
Thermostat. The unit controls are disabled.
The default setting is down (disabled).
r Class 2 (on some models)