GE AJCM 08,10 Owner's Manual & Installation Instructions page 18

Installation Instructions
WINDOW INSTALLATION--OPTIONAL (cont.)
141PREPARE WINDOW
[] Mork the centerline of the stool. Meosure from the
centerline 1B_" on both sides for the ponel cuts.
rBI Meosure 12_" from the centerline on both sides
for the sill support brockets.
Stool
Inside
Sill Centerline
/ i_ ,_. ! ! Outside, : . _i ]
_,'-_-123_" _12_ _,_'_
Inside
Stool
[] INSTALL SILL SUPPORTS
Assemble the sill supports. Do not fully tighten
the spacer mounting screws at this time.
TypeB _ (__
__ Spacer mounting
Sill support " --_ screwsType (A)
Spacer
Locknut
Adjusting bolt---_
Large washer---_
(forusewithwood sills) t
FBI Before ottoching the sill supports, ploce them on
the window stool. Select the spocer position thot
will ploce the spocer neor the outermost point
on the sill. Tighten the spocer mounting screws.
Screwsareinposition
Sillsupport
"V" notch
[] Turn the bolts ond tighten the lock nuts to moke
the sill supports level or tilt down 1/8" to the outside.
Line up the "V" notch with 12_" morks. Drill pilot holes
ond ottoch the sill supports.
Average sill
Sill support i/_
Spacer
Narrowsill
Offsetsill(suchasbrickor stone)
NOTES:
• On norrow sills, there moy not be enough room to use
the lock nut.
• A deep offset sill moy require o longer odjusting bolt
thGn the stondord hex-heod bolt provided.
• On wood sills use the Iorge wosher between the bolt
heod ond the sill. This prevents the bolt from digging
into the wood.
Sill Bolt --
Outside
18