GE AJCM 08,10 Owner's Manual & Installation Instructions page 5

GEAppliances.com
COOL NODE
RemoteControl
1. PressCOOLpad.
2. PressLOW, NED or HIGH pads to set desired fan
speed.
3.Press the INCREASE +/DECREASE - padsto set
the desiredtemperature60°Fto 8S°F in I°F
increments.
ControlPanel
1.Press the MODE pad untilthe COOLindicatorlightis lit
and theLOW,NEDor HIGHindicatorlightis litfor the
desiredfan speed.
2.Press the INCREASE +/DECREASE-padsto setthe
desiredtemperature60°Fto 85°Fin I°F increments.
A thermostatisusedto maintainthe roomtemperature.
Thecompressor w ill cycleon and offto keepthe room
at the set levelof comfort.Setthe thermostatat a lower
numberand the indoorair will becomecooler.
Setthethermostatat a highernumberand the indoorair
will becomewarmer.
NOTE: I f the air conditionerisoff and isthenturnedon
whileset to COOL, i t will take approximately 3 minutes
for the compressor to start and coolingto begin.
Cooling Descriptions
For Normal Cooling-Selectthe COOLmodeand HIGH
or NEDfan with a middlesettemperature.
For MaximumCooling-SelecttheCOOLmode
and HIGHfan with a lowerset temperature.
For Quieterand Nighttime Cooling-Selectthe COOL
modeand LOWfanwith a middleset temperature.
NOTE: I f you switchfrom a COOL settingto OFF or to
a fan setting, w ait at least 3 minutesbeforeswitching
back to a COOL setting.
FAN NODE
Usethe FANmodeto provideair circulationand filtering
without cooling.Since fan-only settingsdo not provide
cooling, a temperaturesettingwill not bedisplayed.
RemoteControl
Press FANpad.Press LOW,NEDor HIGHpadsto set
desiredfan speed.
Control Panel
Press the MODEpad untilthe FANindicatorlightis lit
and the LOW,NED or HIGHindicatorlightislit for the
desiredfan speed.