Care And Cleaning - GE AJCM 08,10 Owner's Manual & Installation Instructions

GEAppliances.com
Terminal Connections Remote Thermostat - Class 2 (on some models)
The controls are located under a plastic cover
behind the front grille.
-] emove the front grille.See the Front Grille
section of Care and Cleaning.
[_ Removethe screws securing the plastic cover
over the wiring connections. Setaside screws
and plastic cover.
-3] To make wiring connections, insert the wires
into the bottom of the terminals and tighten
screws securely.
--] fter all desired connections have been made,
replace the plastic cover and front grille.
The owner is responsible for making all
connections and setting the appropriate dip
switches.
When connected, the unit will be controlled
by a remote thermostat.
NOTE:The number 3 dip switch must be in
the enabled (UP)position to activate the remote
thermostat. (Seethe installation instructions
supplied with the remote thermostat.)
Terminal
connections
location
J underfront
grille
....................... _ .............. _
IHPORTANT:
The thermostat connections provide 24 V AConly.
If using a digital/electronic wall thermostat,
ensure it is compatible with 2/4VACsignal. See
the Installation Instructions for the wall thermostat.
NOTICE:
Damage to a wall thermostat or to the electronics
can result from improper connections. Special
care must be used in connecting the wires. No line
voltage connections should be made to any circuit.
Isolate all wires in building from line voltage.
Red- 24 V AC only
Green- Low SpeedFan
Green- High Speed Fan
Yellow- Compressor
White- Heater
Common - Ground
@@@@@@
9