Utility Commands - AstroStart R SS-5225 User Manual

INDICATOR LIGHT
An optional indicator light (LED) can be added to show the status of the safety sequence (on vehicles equipped with a manual transmission), of the safety
system, the antitheft system or of the Valet Mode.
See 'Indicator Light' in the 'Safety System' Section.
The following table shows the codes displayed by the indicator light when performing the safety sequence.
Repeated flashes
3 double flashes
2 double flashes
1 double flash
1 single flash
Fast (10 sec.)

UTILITY COMMANDS

These commands allow you to control most of the vehicle's accessories depending on what was connected during the installation (headlights, defroster, etc.). For
more information, check with your technician.
To activate these functions, simultaneously press the buttons as shown in the following table. (Fill-up the blanks)
Commands Buttons
UTILITY 1 *
UTILITY 2
The accessory associated to each command is activated for the duration set at time of installation.
The delay can be cancelled by repeating the command.
Programmable at time of installation: the "trunk" command can activate utility 1.
*
CAR FINDER +
Press the and buttons simultaneously.
This function sounds the horn (short melody) and flashes the parking lights so you can locate your vehicle in a large parking lot.
PANIC
To activate the panic mode, press and hold either the
This command activates all deterrents that are connected to the system, parking lights, horn, siren and dome light for 30 sec.
on programming made during installation.
Panic mode is used to attract attention if you are experiencing difficulties.
If you are inside the vehicle when Panic Mode is activated, press on the brake pedal to lock doors (optional connections required) and neutralize antitheft (60
sec. if doors were already unlocked). As long as the cycle is not over, applying the brakes resets the sequence from the beginning every time.
This command will not be executed if the engine is kept running by the ignition key. Use the stop command to abort panic mode.
Phase or Status
Start of sequence.
Door open.
Door closed (waiting for engine to stop).
Valid safety sequence (system is ready to receive a start command).
Invalid sequence (sequence must be started over from beginning).
+
+
or the
Corresponding accessory
button for more than 4 seconds.
Duration
or 60 sec. , depending
18