Connecting External Equipment (2) - Sony DVO-1000MD Instructions For Use Manual

Connecting External Equipment (2)

This section gives an example to connect external
equipment for controlling the unit from connected
external equipment
Settings required for using this connection
example
Make the following settings before operating in this
connection example using SETUP MENU.
For detailed information on menu operation, see "Basic
Menu Operations" on page 55.
• Audio output selection
Select the audio output channel using the AUDIO
MON CH sub menu of SETUP MENU (see page 52).
– LCH: Outputs the audio signal of audio channel 1.
1
S-video cable (not supplied)
2
Audio cable (not supplied)
3
Audio cable (not supplied)
4
RS-232C cable (cross type/not supplied)
7
- AC IN
to AC outlet
Note
You can use only one interface from among RS-232C, USB and
iLINK interfaces to control the unit remotely.
5
6
7
To S-video input connector
AUDIO IN L/R
S-VIDEO IN
REMOTE IN RS-232C
DV IN (i.LINK)
USB
– RCH: Outputs the audio signal of audio channel 2.
– MIX: Outputs a mixed audio signal from both
channel 1 and channel 2. (factory setting)
• Input signal selection
Select the input signal "ANALOG" using the INPUT
SELECT sub menu of SETUP MENU (see page 29).
• Remote control mode selection
Select an interface to control the unit from among
RS232C (factory setting), USB and iLINK (see
page 25).
When controlling the unit, only one interface is
available from among RS232C (factory setting), USB
and iLINK.
DV cable (not supplied)
USB cable (not supplied)
AC power cable (not supplied)
Video monitor
To analog audio input connector
1
3
1
To analog audio
S-VIDEO OUT
output connector
MONITOR AUDIO
to RS-232C connector
4
5 to DV connector
6 to USB connector
2
To S-video
output connector
External equipment
Connection
19