Advertisement
Chime and Status Features
Voice Chime
You can set each Keypad to announce faulted (opened) entry/exit or perimeter zones whenever
the control panel's Chime mode is on by turning on the Voice Chime mode.
Voice Chime On/Off:
Voice Status
You can use the STATUS key to announce system status and display any system and/or zone
faults (if they exist) by first turning on the Voice Chime mode (see above). When Voice Chime
mode is on, pressing the STATUS key displays and announces current system status and zone
descriptors (programmed by your installer) of faulted zones. If zone descriptors are not
programmed, the respective faulted zone numbers are announced.
To Announce Status: Press the [#] FUNCTION + [0] VOICE + [] STATUS key once
To Announce Faults: Press the [] STATUS key a second time within 10 seconds of the first
ÊK0022UGV14Š
K0022UGV1 12/01 Rev. C
Press the [#] FUNCTION + [0] VOICE + [2] VOLUME + [4] keys.
When on, any faulted zone(s) causes a voice status annunciation, chime,
and display. When off, the sounder will still provide chime when the
control's Chime mode is on.
Chime mode must be "on"; see above)
The respective system status is announced (e.g. "Disarmed Ready to
Arm" or "Disarmed Not Ready to Arm").
Note: Status cannot be announced during the Exit Delay period.
press.
Up to 3 faulted zones are announced with their zone descriptors, if
programmed. If zone descriptors are not programmed, the respective
zone numbers are announced.
2 Corporate Center Drive, Suite 100
P.O. Box 9040, Melville, NY 11747
Copyright © 2004 Honeywell International Inc.
www.honeywell.com/security
.
(Voice
Advertisement
