Final Preparation; Performance Checklist; Service & Registration - Viking RVGR330 Installation Manual

Final Preparation

• All stainless steel body parts should be to remove encrusted materials, soak with hot,
wiped with hot, soapy water and with a wet cloths to loosen the material, then use a
liquid cleaner designed for this material. wool or nylon scraper. DO NOT use a metal
If buildup occurs, DO NOT use steel wool, knife, spatula, or any other material tool to
abrasive cloths, cleansers, or powders! scrape stainless steel! Scratches are almost
If it is necessary to scrape stainless steel impossible to remove.

Performance Checklist

A qualified installer should carry out the
following checks:
When conducting performance test, DO
□ Check top burner
NOT run self-clean cycle for more than 10
1-1/2"
ignition. See drawing
(3.8 cm)
minutes with oven racks inside oven. This
for proper flame
could cause them to discolor due to the
height on HI. The low
high temperature required for self-cleaning.
3/8"
flame should light at
(0.95 cm)
every port.
□ Check oven bake function—bake burner on
full power.
□ Check convection fan function—convection
fan comes on when put in Convection Bake
mode.
□ Check broiler function.
□ Check self-clean function—door will lock in
approximately 30 seconds, the broil and
bake burner will turn on. Check broil burner
through window to make sure they are on,
then abort self-clean cycle to unlock door.
20
NOTICE
Service & Registration
Only authorized replacement parts may be used in performing service on the appliance.
All servicing should be referred to a qualified technician.
Contact Viking Range, LLC 1-888-845-4641, for the nearest service parts distributor in your area
or write to:
VIKING RANGE, LLC
PREFERRED SERVICE
111 Front Street
Greenwood, Mississippi 38930 USA
The model and serial number can be found by either tilting range back or
using a mirror to look underneath on the front edge of the bottom base.
Record the following information indicated below. You will need it if service is ever required.
Model number ____________________________________________________________________________________
Serial number _____________________________________________________________________________________
Date of purchase __________________________________________________________________________________
Date installed ______________________________________________________________________________________
Dealer's name _____________________________________________________________________________________
Address ___________________________________________________________________________________________
These installation instructions should remain with the unit
for future reference.
21