Final Installation; Door Replacement And Adjustment - Viking RVGR330 Installation Manual

Final Installation

1
Slide range into place. Be sure
anti-tip bracket slides into the anti-tip opening. cardboard top pack with the grates. Align burner head
3
" " "
3 / 8 3 / 8 3 / 8
) ) )
c m c m c m
9 5 9 5 9 5
( 0 . ( 0 . ( 0 .
Check that unit is level side to side
and front to back. The side trim must be 3/8" (0.95 cm)
above countertop. If unit is not level, repeat Steps 5-7
in "Leveling/Adjustments/Alignment" section.
18
2
Burner heads and burner caps are packed in the
on burner base. Place burner cap on burner head.
Place grate onto the burner pan.

Door Replacement and Adjustment

1
Reattach door to range.
3
Remove pins from holes in hinges.
5
If the door needs to be adjusted, loosen hinge trim screws
located in step 2. Adjust the screws located between the
door and kickplate using a 5/32" hex head Allen wrench.
After adjustment, tighten hinge trim screws.
19
2
1
Open door completely. Reattach hinge trim on both
sides.
4
Close door.