Yamaha DGT7A Advanced Operation Manual page 70

If pause, fast forward or reverse is performed
using the Disklavier panel or remote controller
during MTC sync playback, the MTC sync
playback is suspended. However, sync
playback can be resumed in response to
signals from the external component by
pressing the [STOP] button, and then pressing
the [START] button.
MTC Offset appears only when a song that
supports synchronization has been selected.
The MTC Offset parameter is stored in the
memory even when the power is turned off.
Note: By pressing the [PLAY/PAUSE] button again
in the playback standby mode in step 1, a song
that supports synchronization can also be
played back in the same way as a regular song.
MTC Sync Recording (Slave Mode)
Sync recording is performed while the MTC is
received from the external component. "Slave"
must have already been selected as the MTC/
MTC mode setting.
1
Press [REC] to engage the Record
Standby mode.
The REC indicator lights and the
PLAY/PAUSE indicator flashes.
2
Press [PLAY/PAUSE] and recording
will begin.
The PLAY/PAUSE indicator stops flashing.
3
Operate the external component.
(The external component must
first be set up to serve as the MTC
Master.)
Note: Bear in mind that regular recording will
be performed if you start playing the
song before the MTC message is output
from the external component. (You
must not step on the pedals.)
4
Start playing your song in
synchronization with the external
component.
5
Upon completion of the song,
stop the external component, and
then press [STOP].
Note: MTC sync recording is for recording
new songs only.
Song recorded by MTC sync recording
are supported by MTC synchronization.
Songs recorded by E-SEQ recording,
metronome recording or CD sync
recording are not supported by MTC
synchronization.
Using Disklavier as the MTC
Master
During playback and recording, Disklavier sends
the MTC, and the external component operates in
synchronization with the MTC.
Example of connections
Sending the MTC from MIDI OUT
Control Unit
MIDI OUT
DRIVE SELECT
CONTROL UNIT DKC55RCD
GENERAL
INSTRUMENT
MIDI CABLE
VOLUME –10 –8 –6 –4 –2 0
PLAY/PAUSE STOP REC SONG SELECT/REV • FWD ENTER • • •
TEMPO
TRANSPOSE –/NO +/YES
METRO-
PART VOICE FUNC. NOME BALANCE
STANDBY
ON L R
MTC Mode=Master
Rate = Adjust to the
external component's
rate.
Out=MIDI
External component
equipped with MTC
Slave function
MIDI IN
(MD4S, AW2816, etc.)
Establish the MTC
Slave mode by
following the
instructions in the
manual
accompanying the
external component.
65