Maintenance Of The Mouse; Cleaning The Floppy Disk Drive - Fujitsu DESKPOWER 500 Series User Manual

Maintenance of the mouse

Clean the surface using a soft dry cloth. If the mouse ball does not roll freely, remove and clean the
ball. Take the following steps.
1 Remove the mouse bottom cover.
Remove the cover on the bottom of the mouse by turning it in the direction of the arrow.
2 Remove the ball and clean it with water.
Turn over the mouse to remove the ball. Clean the ball with water.
Ball
3 Clean the inside of the mouse.
Wipe the inside of the mouse, roller, and the bottom cover with a damp cloth.
Roller
4 Reassemble the ball and bottom cover.
When the ball and the inside of the mouse are dry, reassemble the ball and cover.

Cleaning the floppy disk drive

As the floppy disk drive is used for a prolonged period, the head (the part that reads or writes data)
becomes dirty. A dirty head may affect the data reading and writing operation on floppy disks. Using
a separately supplied to clean the floppy drive when you encounter problem.
1 Insert a cleaning floppy disk into the floppy disk drive.
2 At the command prompt (Windows 2000/NT) or MS-DOS prompt (Windows ME), run the
dir or other commands that access the disk.
Example: Enter a command as shown below and press the [Enter] key.
dir a:
3 Confirm that the Floppy disk access lamp is off, then remove the cleaning floppy disk.
57