Ironware Software Release 02.7.03A For Brocade Bigiron Rx Series Swtches - Brocade Communications Systems PowerConnect B-RX Release Note

Multi-service ironware software r02.7.03a for brocade bigiron rx series switches

Hide thumbs Also See for PowerConnect B-RX:

Release note (46 pages)

Release note (40 pages)

Table Of Contents

Table of Contents

Defect ID: DEFECT000284653

Summary: Not able to set Extended IP ACL Protocol field to ESP(50) from SNMP

Symptom: Customer was trying to implement ACL to RX from INM but failed.

Using CLI command the access list is added without any problem

access-list 105 permit esp host 1.1.1.1 host 2.2.2.2

Probability: High

Feature: SNMP Management

Reported In Release: RX 02.7.02

Defect ID: DEFECT000286364

Summary: Change gig auto negotiation behavior.

Symptom: Currently, between two gig fiber interfaces, when one side is configured with gig-default auto

(default), the other side is gig-default neg-off, links show up at both sides. Default behavior will

change to the side with neg-off configured shows link up and the side with auto configured shows link

down. In addition: gig-default auto-full is added to switch back to the current behavior (none-default

behavior after the code change).

Probability: Medium

Feature: SYSTEM

Reported In Release: RX 02.7.02

Defect ID: DEFECT000287890

Summary: BGP "allowas-in" does not with confederation config

Symptom: BGP Routes received from peer with local AS (in as-path) are dropped even though "allowas-in" is

used for that particular peer. We have observed this issue only when confederation is configured.

Without confederation it works fine.

Probability: High

Feature: BGP

Reported In Release: RX 02.7.00

Defect ID: DEFECT000288254

Summary: Under "ipv6 router ospf", the "in" parameter after a "distribute-list prefix-list" isn't saved to the

running config.

Symptom: Under "ipv6 router ospf", the "in" parameter after a "distribute-list prefix-list" isn't saved to the

running config even though it is required when entering a "distribute-list prefix-list". As a result, the

config is lost when the write mem command is issued and the device is reloaded.

Probability: High

Feature: OSPFv3

Reported In Release: RX 02.7.02

Defect ID: DEFECT000288573

Summary: LAG port name was only displayed up to 9 characters.

Symptom: LAG port names are being cutoff in the show lag output.

Probability: Medium

Feature: Character I/O

Reported In Release: RX 02.7.02