Sd Memory Card Installation - D-Link DCS-2332L User Manual

Section 2: Installation
The SD memory card slot is housed behind the lower protective panel on the
rear of the device.
Step 1:
Place the camera face down on a non-slip flat surface
Step 2:
Carefully pry out the two lower protective rubber grommets using a thin flat blade.
Step 3:
Undo the two screws using a Philips #00 Screwdriver.
Step 4:
Lift off the protective panel.
Step 5:
Insert a MicroSD Memory Card.
Step 6:
Replace the protective panel.
Step 7:
Replace the two screws. Ensure that the screws are tightened firmly.
Step 8:
Firmly replace the protective rubber grommets.
Note: To ensure that the camera stays weatherproof, users are advised to ensure
that all the rubber seals are secured firmly in place.
D-Link DCS-2332L User Manual

SD Memory Card Installation

22