Chapter 1 Overview; Introduction; Module Description; Option Numbers - ATI Technologies 100-432001 - RADEON 7500 Multi-monitor Graphics Card Installation Manual

1.1

Introduction

This chapter provides a brief overview of the ATI RADEON 7500 AGP and PCI graphics
controllers.
1.2

Module Description

The ATI RADEON 7500 AGP graphics controller/accelerator module is a single expansion-
slot, 32-bit AGP bus graphics option that provides 2D and 3D graphics acceleration for
supported HP systems.
The ATI RADEON 7500 PCI graphics controller/accelerator module is a single expansion-
slot 32 bit, 66/33 MHZ Universal PCI option that provides 2D and 3D graphics acceleration
for supported HP systems.
Both the AGP and PCI graphics cards are based on ATI's RV200 graphics chip.
Table 1–1 Option Numbers
Option Description
3X-PBXGG-AB ATI RADEON 7500 AGP graphics controller with 64 MB of DDR SDRAM
memory, 2D/3D/Multihead software for OpenVMS and Tru64 UNIX
3X-PBXGG-AA ATI RADEON 7500 PCI graphics controller with 64 MB of DDR SDRAM memory,
2D/3D/Multihead software for OpenVMS and Tru64 UNIX
Note: Purchase and Installation of licenses are required to enable 3D features.
Separately orderable part numbers are:
QL-6ZRA9-AA Tru64 UNIX
QL-0ADA9-AA OpenVMS
For up to date minimum operating system and firmware revision information supported for
the ATI RADEON 7500 graphics controllers, refer to the system QuickSpecs located at
http://www.hp.com.
Chapter 1
Overview
Overview 1-1