Dynex DX-60D260A13 User Manual page 15

Making connections
Using composite video (good)
To connect a cable or satellite box using composite
video:
1
Make sure that your TV's power cord is unplugged,
and all connected equipment is turned off.
2
Connect the incoming cable from the cable wall jack
to the cable-in jack on the cable or satellite box.
3
Connect an AV cable (not provided) to the VIDEO/Y
jack and AV IN AUDIO L/R jacks on the side of your
TV and to the composite video and audio out jacks
on the cable or satellite box.
Note
• The VIDEO/Y, P
connect a component device) share
AV IN AUDIO L/R jacks with the VIDEO/Y jack
(used to connect a composite device).
• When you connect the audio using the
AV IN AUDIO L/R jacks, the audio output is
analog.
Cables are often color-coded to match color-coded jacks.
Side of TV
4
Plug your TV's power cord into a power outlet, turn
on your TV, then turn on the cable or satellite box.
5
Press INPUT to open the INPUT SOURCE list.
6
Press or to highlight COMPONENT/AV then
press ENTER.
, and P video jacks (used to
B R
Cable or satellite box
Using coaxial cable (good)
To connect a cable or satellite box using coaxial cable:
1
Make sure that your TV's power cord is unplugged,
and all connected equipment is turned off.
2
Connect a coaxial cable (not provided) to the
TV IN ANT/CABLE IN jack on the side of your TV and
to the antenna or cable TV wall jack.
Cable or satellite box
Coaxial cable
3
Plug your TV's power cord into a power outlet, then
turn on your TV.
4
Press INPUT to open the INPUT SOURCE list.
5
Press or to highlight TV then press ENTER.
6
If you cannot tune to channels you know exist, scan
for channels. See "Automatically scanning for
channels" on page 24.
Notes
• Use a coaxial cable to eliminate interference and
noise from radio waves.
• Do not bundle the coaxial cable with the power
cord or other cables.
• If the antenna is not installed correctly, contact
qualified service personnel to correct the
problem.
• If the signal level for a channel is weak, the
picture may be distorted. Adjust the antenna or
use a highly directional outdoor or set-top
antenna with a built-in amplifier.
• If the picture quality is good on some channels
and poor on others, the problem may be caused
by a poor or weak signal from the broadcaster
or cable TV provider.
• If you connect to cable or satellite TV without a
set-top box and experience poor picture quality,
you may need to install a set-top box to improve
signal reception and picture quality. Contact
your cable or satellite TV provider about
upgrading to a set-top box.
• Many high-definition (HD) channels upscale
standard-definition (SD) content. The picture
displayed on your TV is still displayed as SD, thus
the picture quality will not be as clear or crisp as
it would be if the content was originally
recorded in HD.
DX-60D260A13
Side of TV
11