Dell PowerVault 100T User Manual page 55

Table 5-5. TapeAlert Flags and Descriptions (continued)
30 1Eh
31 1Fh
32 20h
33 21h
34 22h
36 24h
37 25h
39 27h
51 33h
TapeAlert Flags Supported by the Tape Drive
Hardware A Set when a hardware failure
occurs that requires that you
reset the tape drive to
recover.
Hardware B Set when the tape drive fails
its internal self tests.
Interface Set when the tape drive
detects a problem with the
SCSI or LDI (RS-422)
interface.
Eject media Set when a failure occurs that
requires you to unload the
cartridge from the drive.
Download fail Set when a field microcode
replacement (FMR) image is
unsuccessfully downloaded
to the tape drive via the SAS
interface.
Drive temperature Set when the drive's
temperature sensor indicates
that the drive's temperature
is exceeding the
recommended temperature of
the system (see Chapter 6,
"Specifications," on page
6-1).
Drive voltage Set when the drive detects
that the externally supplied
voltages are either
approaching the specified
voltage limits or are outside
the voltage limits (see
Chapter 6, "Specifications,"
on page 6-1).
Diagnostics required Set when the drive detects a
failure that requires
diagnostics to isolate the
problem.
Tape directory invalid Set when the tape directory
at unload on the tape cartridge that
was previously unloaded is
corrupted. The file-search
performance is degraded.
If resetting the drive does not
recover the error, use the
error code from the
single-character display,
library user interface, or SCSI
drive sense data. See
"Descriptions and Corrective
Actions" on page 5-10.
Use the error code on the
single-character display,
library user interface, or SCSI
drive sense data. See
"Descriptions and Corrective
Actions" on page 5-10.
Locate error code 8 or 9 in
"Descriptions and Corrective
Actions" on page 5-10.
Unload and reload the tape
cartridge.
Ensure that it is the correct
image. Download the FMR
image again.
See error code 1 in
"Descriptions and Corrective
Actions" on page 5-10.
See error code 2 in
"Descriptions and Corrective
Actions" on page 5-10.
See error code 6 in
"Descriptions and Corrective
Actions" on page 5-10.
Rebuild the tape directory by
reading all the data.
Chapter 5. Troubleshooting
5-19