Dell PowerVault 100T User Manual page 54

Table 5-5. TapeAlert Flags and Descriptions (continued)
9 09h
10 0Ah
11 0Bh
12 0Ch
15 0Fh
16 10h
18 12h
20 14h
21 15h
22 16h
23 17h
5-18
Dell PowerVault LTO Tape Drive User's Guide
TapeAlert Flags Supported by the Tape Drive
Write protect Set when the tape drive
detects that the tape
cartridge is write-protected.
No removal Set when the tape drive
receives an UNLOAD
command after the system
prevented the tape cartridge
from being removed.
Cleaning media Set when you load a cleaning
cartridge into the drive.
Unsupported format Set when you load an
unsupported cartridge type
into the drive or when the
cartridge format has been
corrupted.
Cartridge memory chip Set when a cartridge memory
failure (CM) failure is detected on
the loaded tape cartridge.
Forced eject Set when you manually
unload the tape cartridge
while the drive was reading
or writing.
Tape directory Set when the drive detects
corrupted in the that the tape directory in the
cartridge memory cartridge memory has been
corrupted.
Clean now Set when the tape drive
detects that it needs cleaning.
Clean periodic Set when the drive detects
that it needs routine cleaning.
Expired clean Set when the tape drive
detects a cleaning cartridge
that has expired.
Invalid cleaning tape Set when the drive expects a
cleaning cartridge and the
loaded cartridge is not a
cleaning cartridge.
Make sure that the
cartridge's write-protect
switch is set so that the tape
drive can write data to the
tape (see the "Setting the
Write-Protect Switch on Tape
Cartridges" on page 3-4
section).
Refer to the documentation
for your system's operating
system.
No action required.
Use a supported tape
cartridge.
Replace the cartridge. If this
error occurs on multiple
tapes, see error code 6 in
"Descriptions and Corrective
Actions" on page 5-10.
No action required.
Reread all data from the tape
to rebuild the tape directory.
Clean the tape drive. See the
"Cleaning the Tape
Mechanism" on page 3-7
section.
Clean the tape drive as soon
as possible. The drive can
continue to operate, but you
should clean the drive soon.
See the "Cleaning the Tape
Mechanism" on page 3-7
section.
Replace the cleaning
cartridge.
Use a valid cleaning
cartridge.