Table of Contents
Advertisement
4.4.3
Remote Access Configuration
The items in this menu allows you to configure the Remote Access
features. Select an item then press <Enter> to display the configuration
options.
Advanced
Configure Remote Access type and parameters
Remote Access
Serial port number
Base Address, IRQ
Serial Port Mode
Flow Control
Redirection After BIOS POST
Terminal Type
VT-UTF8 Combo Key Support
Media Type
Remote Access [Enabled]
Enables or disables the remote access feature.
Configuration options: [Disabled] [Enabled]
The following items appear only when the Remote Access item is set to
[Enabled].
Serial port number [COM1]
Allows you to select a serial port for console redirection. Configuration
options: [COM1] [COM2]
Serial Port Mode [115200 8, n,1]
Allows you to select a serial port mode. Configuration options: [115200
8,n,1] [57600 8,n,1] [38400 8,n,1] [19200 8,n,1] [09600 8,n,1]
Flow Control [None]
Allows you to set the flow control for console redirection. Configuration
options: [None] [Hardware] [Software]
Redirection After BIOS POST [Always]
Sets the redirection mode after the BIOS Power-On Self-Test (POST). Some
operating systems may not work when this item is set to Always.
Configuration options: [Disabled] [Boot Loader] [Always]
4-20
v02.58 (C)Copyright 1985-2004, American Megatrends, Inc.
BIOS SETUP UTILITY
[Enabled]
[COM1]
[3F8h,4]
[115200 8, n,1]
[None]
[Always]
[ANSI]
[Enabled]
[Serial]
Select Remote Access
type.
Select Screen
Select Item
+-
Change Option
F1
General Help
F10 Save and Exit
ESC Exit
Chapter 4: BIOS setup
Advertisement
Table of Contents
