Table of Contents
Advertisement
II. System Components
• 2-5. Installation of DA3000 RAID Controller
Top Panel of DA3000
Clip
Mounting Hole
Plastic Safety Tab (This Side Only)
Installing DRAM SIMM
The DA3000 RAID controller is equipped with two SIMM sockets. A mini-
mum of 8 MB of DRAM in one SIMM is required for it to operate.
SIMM Memory Installation Procedures:
1. The SIMM memory modules will fit in only one orientation as shown
because the plastic safety tab on one end of the SIMM socket requires the
notched end of the SIMM memory modules.
2. Press the memory module firmly into place starting from a 45-degree angle,
making sure that all the contacts are aligned with the socket.
3. With your fingertips, rock the memory module into a vertical position so
that it clicks into place. The plastic guides should go through the two
mounting holes and the clips should snap.
To release the memory module, push both clips outward and rock the
module out of the clips.
AR1000 RAID Subsystem Hardware Reference Guide
The top panel of the DA3000
RAID controller is secured by
four screws, two on each side (as
circled). To install the DRAM
SIMM, open the top panel by
removing the four screws.
72-Pin DRAM in SIMM Socket
Opening the Top
Panel
Mounting Hole
17
Advertisement
Table of Contents
