Advertisement
Quick Links
Advertisement
Related Manuals for Asus AP1400R 1U
Summary of Contents for Asus AP1400R 1U
-
Page 1: Installation Guide
A631 Rackmount Installation Guide English ® 1U Rackmount Kit Installation Guide... - Page 2 Content English.............3 ............11 .............19 ............27 English...
- Page 3 English This installation guide provides a step- by-step procedure on how to install the AP1400R 1U Rackmount Server into a 4-post 19-inch industrial rack. 1U Rackmount Kit Installation Guide...
-
Page 4: Rackmount Kit Contents
Introduction Rackmount Kit Contents The AP1400R 1U Server Rackmount Kit includes the following items: 1. Chassis Rails (1 pair) 2. Rack Slides with extensions (1 pair) 3. Spacers (2 pairs) 4. Mounting Ears (1 pair) 5. Screws Tool Required You will need one Phillips screwdriver to secure the rails and slides. - Page 5 Attach the Spacers and Ears The 1U server has side holes to accommodate the spacers and mounting ears. 1. Align a mounting ear with the holes on a front corner of the chassis. 2. Secure the mounting ear using two screws. 3.
- Page 6 Attach the Chassis Rails The chassis rails are two metal pieces a few inches longer than the the 1U chassis. Note that one end of a rail is straight and the other end is curved. 1. Align a rail on one side of the chassis, matching the straight end with a mounting ear.
- Page 7 Attach the Rack Slides Each rack slide includes an extension piece attached to it with a screw. You need to pull this extension so that the slide reaches the rear end of the rack. NOTE Racks vary in depth and require different length of slides. The extension was designed to serve this purpose.
- Page 8 Attach the Rack Slides Secure the Rear End 1. Find the 1U space on the rear of the rack that corresponds to the front 1U space where you attached the slide. 2. Remove the screws from the rear 1U space. 3.
- Page 9 Mount the Server When rails and slides are completely installed, you are now ready to mount the server to the rack. 1. Firmly hold the server on both sides and align the chassis rails with the rack slides. 2. Push the server all the way to the back until its front panel fits the front edge of the rack.
- Page 10 Attach the Front Panel Faceplate For further protection of the hard disk drives, attach the front panel faceplate. 1. Attach the bottom edge of the faceplate to the hooks on the lower corners of the chassis. 2. Swing the upper edge of the faceplate until the clips fit in place. NOTE When the server is settled on the rack, connect the cables to the rear ports.
- Page 35 MEMO...
- Page 36 ® w w w . a s u s . c o m 15-XXXXXXXXX...