Brother HL-S7000DN Settings Manual page 9

IPsec Settings
Template Name

Enter a name for the template in this box. (Maximum of 16 characters)
 Local IP Address
Specify the IP address conditions for the sender.
• IP Address
Specify the IP address. Select ALL IPv4 Address, ALL IPv6 Address, All Link Local IPv6, or
Custom.
If Custom is selected, enter the specified IP address (IPv4 or IPv6) in the text box.
• IP Address Range
Enter the starting and ending IP addresses for the IP address range. If the starting and ending IP
addresses are not standardized to IPv4 or IPv6, or the ending IP address is smaller than the
starting address, an error will occur.
• IP Address / Prefix
Specify the IP address using a prefix.
For example: 192.168.1.1/24
Because the prefix is specified in the form of a 24-bit subnet mask (255.255.255.0) for 192.168.1.1,
the addresses 192.168.1.xx are valid.
 Remote IP Address
Specify the IP address conditions for the recipient.
• Any
When Any is selected, all IP addresses are enabled.
• IP Address
Enter the specified IP address (IPv4 or IPv6) in the text box.
• IP Address Range
Enter the starting and ending IP addresses for the IP address range. If the starting and ending IP
addresses are not standardized to IPv4 or IPv6, or the ending IP address is smaller than the
starting address, an error will occur.
• IP Address / Prefix
Specify the IP address using a prefix.
For example: 192.168.1.1/24
Because the prefix is specified in the form of a 24-bit subnet mask (255.255.255.0) for 192.168.1.1,
the addresses 192.168.1.xx are valid.
 Submit
Click this button to register the settings.
Note
When you change the settings of the currently used template, the IPsec setting screen for Web Based
Management will close and open again.
2
6