Fujitsu MHV2060AT Product Manual page 162

Interface
Bit 5: *
Bit 4:
Bit 3-2:
Bit 1:
Bit 0:
*18 WORD 88
Bit 15-8:
Bit 7-0:
*19 WORD 89 (Value × 2 minutes)
MHV2120AT = X'3C 120 minutes
MHV2100AT = X'32 100 minutes
MHV2080AT = X'28 80 minutes
MHV2060AT = X'1E': 60 minutes
MHV2040AT = X'14': 40 minutes
*20 WORD 93
Bits 15:
Bit 14:
Bit 13:
5-86
'1' = Supports the General Purpose Logging feature set
'1' = Valid Configure Stream command has been executed
Reserved
'1' = Supports the SMART SELF-TEST.
'1' = Supports the SMART Error Logging
Currently used Ultra DMA transfer mode
Bit 13: '1' = Mode 5 is selected.
Bit 12: '1' = Mode 4 is selected.
Bit 11: '1' = Mode 3 is selected.
Bit 10: '1' = Mode 2 is selected.
Bit 9: '1' = Mode 1 is selected.
Bit 8: '1' = Mode 0 is selected.
Supportable Ultra DMA transfer mode
Bit 5: '1' = Supports the Mode 5
Bit 4: '1' = Supports the Mode 4
Bit 3: '1' = Supports the Mode 3
Bit 2: '1' = Supports the Mode 2
Bit 1: '1' = Supports the Mode 1
Bit 0: '1' = Supports the Mode 0
= 0
= '1'
'1' = CBLID- is a higher level than VIH (80-conductor cable).
'0' = CBLID- is a lower level than VIL (40-conductor cable).
C141-E218