Fujitsu MHR2010AT Product Manual page 97

At command issuance (I/O registers setting contents)
1F7 (CM)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (FR)
H
At command completion (I/O registers contents to be read)
1F7 (ST)
H
1F6 (DH)
H
1F5 (CH)
H
1F4 (CL)
H
1F3 (SN)
H
1F2 (SC)
H
1F1 (ER)
H
*1 If the command is terminated due to an error, the remaining number of
sectors of which data was not transferred is set in this register.
(4) READ VERIFY SECTOR(S) (X'40' or X'41')
This command operates similarly to the READ SECTOR(S) command except that
the data is not transferred to the host system.
After all requested sectors are verified, the device clears the BSY bit of the Status
register and generates an interrupt. Upon the completion of the command
execution, the command block registers contain the cylinder, head, and sector
number of the last sector verified.
If an unrecoverable error occurs, the verify operation is terminated at the sector
where the error occurred. The command block registers contain the cylinder, the
head, and the sector addresses (in the CHS mode) or the logical block address (in
the LBA mode) of the sector where the error occurred. The Sector Count register
indicates the number of sectors that have not been verified.
C141-E145-02EN
1 1 0 0
x L x DV
Start cylinder No. [MSB] / LBA
Start cylinder No. [LSB] / LBA
Start sector No. / LBA [LSB]
Transfer sector count
xx
Status information
x L x DV
End cylinder No. [MSB] / LBA
End cylinder No. [LSB] / LBA
End sector No. / LBA [LSB]
00 (*1)
Error information
5.3 Host Commands
1 0 0 R
Start head No. / LBA
[MSB]
End head No. / LBA [MSB]
5-23