Fujitsu MHR2010AT Product Manual page 120

Interface
Multiword DMA transfer mode X
Ultra DMA transfer mode X
*2) Advanced Power Management (APM)
The host writes the Sector Count register with the desired power management
level and executes this command with the Features register X'05', and then
Advanced Power Management is enabled.
The drive automatically shifts to power saving mode up to the specified APM
level when the drive does not receive any command for a specific time. The
power management level is shifted from Active Idle, and Low power Idle to
Standby. The Mode-2 takes the maximum shifting time in the APM level. The
APM level setting is preserved by the drive across power on, hardware and
software resets.
Active Idle
Low Power Idle
Standby
*3) Automatic Acoustic Management (AAM)
The host writes to the Sector Count register with the requested acoustic
management level and executes this command with subcommand code 42h, and
then Automatic Acoustic Management is enabled. The AAM level setting is
preserved by the drive across power on, hardware and software resets.
5-46
APM Level
Mode-0 Active Idle
Mode-1 Low Power Idle
Mode-2 Standby
Reserved
: The spindle motor is rotating and heads are loaded on
the medium.
: The spindle motor is rotating and heads are unloaded
from the ramp.
: The spindle motor is not rotating and heads are
unloaded from the ramp.
00100 000 (X'20': Mode 0)
00100 001 (X'21': Mode 1)
00100 010 (X'22': Mode 2)
01000 000 (X'40': Mode 0)
01000 001 (X'41': Mode 1)
01000 010 (X'42': Mode 2)
01000 011 (X'43': Mode 3)
01000 100 (X'44': Mode 4)
01000 101 (X'45': Mode 5)
Sector Count register
C0h-FEh
80h-BFh
01h-7Fh
FFh, 00h
C141-E145-02EN