Table of Contents
Advertisement
PEG0 De-emphasis Control
PEG0:Configure the De-emphasis control on PEG.
Options available: Options available: -6 dB/-3.5 dB. Default setting is -3.5 dB.
PEG1 De-emphasis Control
PEG1:Configure the De-emphasis control on PEG.
Options available: Options available: -6 dB/-3.5 dB. Default setting is -3.5 dB.
PEG2 De-emphasis Control
PEG2:Configure the De-emphasis control on PEG.
Options available: Options available: -6 dB/-3.5 dB. Default setting is -3.5 dB.
PEG0 - ASPM
Control ASPM support for the PEG Device. This has no effect if PEG is not the currently active device.
Options available: Enabled/Disabled. Default setting is Disabled.
PEG1 - ASPM
Control ASPM support for the PEG Device. This has no effect if PEG is not the currently active device.
Options available: Enabled/Disabled. Default setting is Disabled.
PEG2 - ASPM
Control ASPM support for the PEG Device. This has no effect if PEG is not the currently active device.
Options available: Enabled/Disabled. Default setting is Disabled.
PEG Sampler Calibrate
Enable or disable PEG Sampler Calibrate\nAuto means Disabled for SNB MB/DT, Enabled for IVB A0
B0.
Options available: Enabled/Disabled. Default setting is Disabled.
Swing Control
Perform PEG Swing Control, on IVB C0 and Later.
Options available: Reduced/Half/Full. Default setting is Full.
PEG Gen3 Equalization
Perform PEG Gen3 Equalization steps.
Options available: Enabled/Disabled. Default setting is Enabled.
Gen3 Eq Phase 2
Perform PEG Gen3 Equalization Phase 2.
Options available: Enabled/Disabled. Default setting is Enabled.
Gen3 Eq Preset Search
Perform PEG Gen3 Preset Search algorithm, on IVB C0 and Later.
Options available: Enabled/Disabled. Default setting is Enabled.
PEG RxCEM LoopBack Mode
Options available: Enabled/Disabled. Default setting is Disabled.
BIOS Setup
- 68 -
Advertisement
Table of Contents
