Control Panel; Odor Removal; Turntable/Turntable Support; Waveguide Cover - Viking RVM320 Use And Care Manual

Cleaning and Maintenance

Control Panel

Care should be taken in cleaning the touch control panel. If the control
panel becomes soiled, open the oven door before cleaning. Wipe the
panel with a cloth dampened slightly with water only. Dry with a soft
cloth. Do not scrub or use any sort of chemical cleaners. Close door
and touch STOP/Clear.

Odor Removal

Occasionally, a cooking odor may remain in the oven. To remove,
combine 1 cup water, grated peel and juice of one lemon and several
whole cloves in a 2-cup glass measuring cup. Boil for several minutes
using 100% power. Allow to set in the microwave until cool. Wipe
interior with a soft cloth.

Turntable/Turntable Support

The turntable and turntable support can be removed for easy cleaning.
Wash them in mild, sudsy water; for stubborn stains use a mild cleanser
and non-abrasive scouring sponge. They are also dishwasher-proof. Use
upper rack of dishwasher. The turntable motor shaft is not sealed, so
excess water or spills should be wiped up immediately.

Waveguide Cover

The waveguide cover is located on the right side wall of the oven
cavity. It is made from mica so requires special care. Keep the
waveguide cover clean to assure good oven performance. Carefully
wipe with a damp cloth any food spatters from the surface of the
cover immediately after they occur. Built-up splashes may overheat
and cause smoke or possibly catch fire. DO NOT REMOVE THE
WAVEGUIDE COVER.
33
E