Table of Contents
Advertisement
5
When you wish to scan only a portion of the entire image, drag the mouse to specify the
portion. (The specified portion is called a "Selection Box" and only the area in the selection
Box will be scanned.) To specify the Selection Box, follow the procedure below.
1) Point to a corner of the rectangular area of the image that you want to select.
2) Drag the mouse to the opposite corner of the rectangle.
3) Release the mouse button. The specified rectangle (the selection box) appears on the
image.
• When you wish to move the Selection Box, place the mouse pointer within the selection
Note
Box and drag the mouse to the desired position.
• When you wish to resize the selection box, move the mouse pointer to one of the eight
points around the Selection Box and then drag the mouse.
• You can confirm the dimensions of the selection box on the lower left corner of the
screen.
• The minimum size of the Selection Box is 25.4 mm
6
Load the image you wish to scan in the auto sheet feeder again.
7
Click the Scan button. (If you specified a selection box in Step 5, only a portion of the entire
image is scanned.)
25.4 mm (1"
1").
Using Capture Photo
33
Advertisement
Table of Contents
