Garmin G2000 Cockpit Reference Manual page 143

System Message
GPS1 SERVICE – GPS1 needs
service. Return unit for repair.
GPS2 SERVICE – GPS2 needs
service. Return unit for repair.
GPS1 FAIL – GPS1 is
inoperative.
GPS2 FAIL – GPS2 is
inoperative.
NAV1 SERVICE – NAV1 needs
service. Return unit for repair.
NAV2 SERVICE – NAV2 needs
service. Return unit for repair.
NAV1 RMT XFR – NAV1
remote transfer key is stuck.
NAV2 RMT XFR – NAV2
remote transfer key is stuck.
G/S1 FAIL – G/S1 is inoperative.
G/S2 FAIL – G/S2 is inoperative.
G/S1 SERVICE – G/S1 needs
service. Return unit for repair.
G/S2 SERVICE – G/S2 needs
service. Return unit for repair.
NAV1 MANIFEST – NAV1
software mismatch,
communication halted.
NAV2 MANIFEST – NAV2
software mismatch,
communication halted.
190-01264-01 Rev. A
Comments
A failure has been detected in the GPS1 and/or GPS2
receiver. The receiver may still be available. The system
should be serviced.
A failure has been detected in GPS receiver #1 and/or
GPS receiver #2. The system should be serviced.
A failure has been detected in the NAV1 and/or NAV2
receiver. The receiver may still be available. The system
should be serviced.
The remote NAV1 and/or NAV2 transfer switch is stuck
in the enabled (or "pressed") state. Press the transfer
switch again to cycle its operation. If the problem
persists, the system should be serviced.
A failure has been detected in glideslope receiver 1 and/
or receiver 2. The system should be serviced.
A failure has been detected in glideslope receiver 1 and/
or receiver 2. The receiver may still be available. The
system should be serviced when possible.
The NAV 1 and/or NAV 2 has incorrect software
installed. The system should be serviced.
Garmin G2000 Cockpit Reference Guide for the Cessna Corvalis T240
Annunciations & Alerts
127