Installing the Microprocessor Airflow Shroud
1. Follow the instructions in
"Before You
2.
Open the computer
cover.
3. Insert the bottom anchor tabs into the anchor slots.
4. Align and insert the side anchor tabs into the anchor slots.
5. Press the indentations until the top anchor tabs on the shroud snap securely into place.
6.
Close the computer
cover.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.
7. Connect your computer and devices to electrical outlets, and turn them on.
Microprocessor
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in your Owner's Manual.
Installing the Microprocessor
NOTE:
It is recommended that only a technically knowledgeable person perform this procedure.
CAUTION:
The processor can get very hot during normal operation. Ensure that the processor has had sufficient time to cool before you touch it.
1. Follow the instructions in
"Before You
2.
Open the computer
cover.
3.
Remove the microprocessor airflow
If you are replacing a microprocessor, see
NOTICE:
You must position the microprocessor correctly in the socket to avoid permanent damage to the microprocessor and the computer.
4. If the release lever is not extended to the release position, move it to that position.
Begin."
Begin."
shroud.
"Removing the
Microprocessor."